| |
|
Customer Testimonial:
"The mat has been at two stations for approximately 4 weeks now. They have been exposed to typical chemicals, flux, alcohol, etc. One operator even sent a piece through our washing machine. We measured them today and they are well within the 10E6 - 10E9 range. Quite frankly, I'm very impressed with how durable this material is.
Looks like we found the solution we were looking for. Thanks!"
Click HERE for detailed information
Click here for cleaners for your mats.
|
| |
|
In stock - will ship in 3 days or less
Solid fiberboard construction with a buried conductive layer
Includes two installed 3/8" stud snaps - socket snaps available
Resists damage by hot soldering irons, solder, or flux
RTT of top and bottom layers: 10E6 - 10E8 ohms - meets worksurface recommendation of ANSI/ESD S4.1
Thickness: 0.060" (1.5mm)
Lead-free RoHS compliant
Made in America
"The most important functional consideration for worksurfaces is the RTG resistance from the top of the surface to the groundable point." ANSI/ESD S20.20 Table 1 recommends a requirement of less than 1 X 10^9 ohms. "If Charged Device Model damage is a concern then setting a lower resistance limit should be considered. Typically, 1 x1 0^6 ohms." "Durability factors that should be considered are hardness, abrasion resistance, tear resistance, etc. Worksurfaces may require special heat resistant materials. Light reflection may be an important ergonomic consideration." (Ref: TR 20.20 section 5.3.1).
|
|